Table of Contents

Preface / Mitigation of Seismic Response of Five Storey Building Using Multiple Tuned Mass Dampers / Seismic Performance of I-beam Bridges Considering Different Skew Angles / Effect of Precompression on Thermal Vibration Characteristics of Boron Nitride Nanotubes / Dynamic Stiffness of an Infinite Taut String Supported by a Viscoelastic Layer and Subjected to Moving Loads / Soft Storey Collapse Prevention Of Rc Building Under Earthquake Load Using Rc Filled Steel Tubes / Control of Internal Resonance of Nonlinear Coupled Roll-Pitch Motion Using Time-Delayed State Feedback / Improvement of Energy Efficiency of an On-Off Controlled Hydraulic System Using Soft Switch: A Study with Energetically Consistent Bond Graph Model / Engineering Significance of Aftershocks: A Retrospective to 2015 Nepal Earthquake / Implications of Site Characteristics on Engineering Properties of Ground Motions Using Wavelets / A Literature Review on Diagrid Structural System / Static Response of Quasi Isotropic Laminated Plates Excited by smart Piezoelectric Actuators with Variable Thickness Ratios / Dynamic Analysis of Steel and Reinforced Concrete Chimney: A Review / Response of various components under seismic loads of RCC building- A review / Experimental Investigation Of Velocity Control Of Electro-Hydraulic Linear Actuator Using Fuzzy Pid Controller / Vibration Analysis of Rotating Isotropic and Composite Smart Plates using FEM / Experimental Investigation of Unbalance in a Rotor Bearing System Using Vibration Analysis and Phase Analysis / Model Based Fault Diagnosis of a Rotor Bearing System: Crack Versus Unbalance / Seismic Performance Evaluation of Setback Buildings Using Nonlinear Static and Dynamic Methods / Dynamic Behaviour of Plate Girder Railway Bridge Under Varying Speeds: A Case Study / MRE Based Adaptive Tuned Vibration Absorber for Powertrain Transient Vibration Reduction / A Study on the Seismic Performance of RC Building with Masonry Infills / Seismic Evaluation of Plan Asymmetric Building Using Nonlinear Static and Dynamic Analysis / Convergence Study For Natural Frequency Of Rotor System Supported on Rigid Bearing / Tuning of Centralized PID Controllers by BLT Method for Unstable TITO Systems / Parametric Study on Variation of Fundamental Time Period of RC Building with Vertical Irregularities / Control of Electric Power Assisted Steering System using Model Predictive Control / Prediction of Stability Lobe Diagram in High Speed Ball End Milling Using Inverse Method / Free Vibration Analysis of Cross-Ply Laminated Bimodular Beam Using Equivalent Stiffness Method / Numerical Study on Chaotic Behaviour of Slip and Ageing Laws of the Rate and State Friction / The Effect of Ultra Sonic Vibration on the Surface Integrity of SS304 Micro Holes Drilled by Micro EDM / Damage Detection in Ball Bearings using Vibration Signature Analysis / Detection and Stiffness Analysis of Inclined Height Crack in Cantilever Beam using Strain Energy Analysis / Dynamic Control of Hybrid Laminated Plate with Integrated PZT-5H Actuator / Damage Detection Of A Hat Stiffened Plate Using Experimental Modal Analysis / Design and Modeling of a Flexible Acoustic Horn for Ultrasonic Vibration Assisted Turning / Performance of Microbial fuel cell and its dynamic parameters control through MATLAB Simulation / Stability and Hand-stand Control of a Cart-Double Inverted Pendulum / Machining Dynamics of a Turning Centre: A Case Study / Static Analysis of Single Drum Vibratory Soil Compactor Chassis / Effect of damping on vortex-induced vibrations of a square cylinder at low Reynolds numbers / Buckling Analysis of Piston Rod for Hydraulic Cylinder of Cotton Bale Press Machine / A Review Of Progressive Collapse Research And Regulations / Variation of Wave Force on Vertical Thin Plate: Second-Order Stokes Wave Theory / Review on the Free Vibration Analysis of Laminated Composite and Sandwich Plates with Soft Core with Some Numerical Results / Design Modification of Fixture from 4-axis to 5-axis orientation / Non-planar Coupled Motions in a String Vibrating against a Smooth Unilateral Obstacle: Relevance to Indian Stringed Musical Instruments / Geosynthetic as Seismic Protection of Embankment / Fuzzy Logic Based Solar PV Power Prediction / Momentum Correction for Energy Conservation in Smooth Particle Hydrodynamics / Hydrodynamic Viscous Friction Analysis of Piston Ring and Cylinder Liner Contact / Bio-Slurry : An Important Factor For Sustainable Development And Parametric study of portable type biogas plant / Free Vibration Analysis of Laminated Sandwich Beam Structures / Structural Performance of Ultra High Strength Fibrous Concrete Beam Column Joints: An Overview / Detection of Damage in Beam from Measured Natural Frequencies Using Support Vector Machine Algorithm / Effects of Biodiesel from Non Edible Oils on Engine Performance and Exhaust Emission: A Review / Effect of Blast induced Shock on Structures and Foundations: A Critical Review / Sustainable development by Biogas & Bio-Slurry using algae and cow dung as substrates / Assessment of sustainable biogas production from algae and poultry waste / Structural Analysis of seven link kinematic chain using graph theory / Finite Element Analysis of a Fishplate Rail Joint due to Wheel Impact / On The Role of Electrorheological Fluids in EHL Line Contacts During Film Collapse Due to Sudden Halt / Molecular Modeling and Computing for PDZ Protein (alpha-1 Syntrophin) from Homo sapiens: A Comparative Optimization Approach for Protein/Drug Affinity / Dynamic Amplification Factor of Highway Bridges: An State of Art Review / Oil Whirl Detection in a Rotor-Bearing System Coupled with a 3-phi Induction Motor using Bond Graph / Surface Roughness Effects in Elastohydrodynamic Lubrication of Line Contacts with Smart Lubricants / Development of Methodology for Seismic Design of Concrete Gravity Dam / Design Optimization of Bamboo Round Stick Machine by FEM / Finite Element Analysis of a Multi-Leaf Parabolic Leaf Spring using CAE Tools / Finite Element Analysis of Forged Ramshorn Hook Using CAE Tools / Metallurgical Investigation of Camshaft of Four Stroke Engine / Sliding Mode Control of Multi-Span Bridges / Transient Modelling of Induction Machine using Winding Function Method under Stator Fault / Metallurgical Analysis of Crankpin of Four Stroke Single Cylinder Petrol Engine / Coupled analysis and parametric study of a Spar shaped structure with different mooring cable configurations / Static and Dynamic Analysis of offshore jacket platform / Dynamic Responses of an FPSO with Mooring Cables Interacting with Different Bed Slopes / Identification of Isomorphism and inversion of Kinematic Chains Using Eigenvalues and Eigenvectors Technique / Linear and Nonlinear Coupled Analysis of Moored Floating Structure: A State-of-The Art Review / Review of application of shape memory alloys in civil structure / Progressive Collapse of Moment Resistance Steel building Subjected to Multi Hazard Loads: a Review Study / Design of Robust PID control for Twin Rotor MIMO System (TRMS) based on Kharitonov's theorem / Nonlinear Dynamic Progressive Collapse of Semi-Rigid Jointed Steel Frames / Comparative Study of Reflecting and Non-Reflecting Boundary Condition for Blast Loading / Modeling Of The Non-Linear Dynamic Analysis Of Pile Embedded In Soil Using Finite Element Method: A Review / Seismic Response of Elevated Liquid Storage Steel Tanks Isolated by Conical Friction Pendulum Isolator at Top of Tower under Near-Fault Ground Motions / SPH and Non SPH Damage of Bridge under Blast using FEM-SPH Coupling / Signal Estimation of Response of a Two-Degree Freedom System using Wavelet Transformation / Effect of Seabed Soil Characteristics on Natural Frequency of Free Spanning Offshore Pipelines / Fault Diagnosis Of Boiler Feed Water Pump Using Vibration Analysis: Case Study.